Kangaroo joey feeding pump manual






















1. Fill or spike feeding container prior to setting up pump. 2. Turn pump on – Press Power button in lower right-hand corner. 3. In order to achieve proper accuracy, the fluid line in the feeding set bag must be 6 inches above the top of the feeding pump, when initiating the feeding cycle. 4. CLINICAL CARE DIVISION 15 HAMPSHIRE STREET [T] MANSFIELD, MA [FAX] Dear Valued Customer, Please refer to the instructions below when cleaning your Kangaroo™ enteral feeding pump. Disconnect pump from AC power source before cleaning. The Kangaroo™ Joey enteral feed and flush pump with pole clamp is a simple-to-use, precision enteral feeding pump. It is easily programmed to provide patients with either continuous or intermittent feeding, and can provide automatic flushing capability when.


Kangaroo™ Joey enteral pump loading and feeding set rinsing racy, the fluid level in the feed-ing set bag must be 6 inches above the top of the feeding pump when the feeding cycle is initiated. 4. Fill the feed bag with water to approximately half of the total Operating Manual for the Kangaroo™ Joey Enteral Feed and Flush Pump with. The Kangaroo Connect enteral feeding pump is a portable rotary peristaltic enteral feeding pump, intended to provide enteral nutrition to a patient. It can be programmed to provide patients with continuous, dose, or bolus feeding when used with Kangaroo Connect feeding sets. 1. Fill or spike feeding container prior to setting up pump. 2. Turn pump on - Press Power button in lower right-hand corner. 3. In order to achieve proper accuracy, the fluid line in the feeding set bag must be 6 inches above the top of the feeding pump, when initiating the feeding cycle. 4.


The Kangaroo Epump Enteral Feed and Flush Pump with Pole Clamp is a simple-to-use, precision enteral feeding pump. It is easily programmed to provide patients with either continuous or intermittent feeding, and can provide automatic flushing capability when used with Kangaroo™ Epump Feed Flush Sets. User Interface: • Intuitive user interface. of feeding pump 1. Grasp thumb tab on valve and insert into left pocket — ensure valve is fully seated. Thumb tab should align with slot in blue door. 2. Grasp black ring retainer, gently wrap tubing around rotor and insert retainer directly into right pocket. Do not overstretch tubing. 3. To properly unload a pump set, power off the pump and wait. Using A Kangaroo ™ Joey Feeding Pump - 8 - “hold”. Choose “run” when you are ready to re-start the feeding. The pump can be on “hold” for 10 minutes before it alarms. 4. When the feeding is done, press and hold the power button (which looks like this:) until the pump shuts off. Throw the bag out if it has been.

0コメント

  • 1000 / 1000